cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

sheetmetal bend note orientation

Newbie

sheetmetal bend note orientation

I copied ansheet metal part and got the drawing copied as well. When I showed the bend notes for the new part, the notes had moved from above the line to below the line. See Attached. This is consistant throughout the drawing. Does anyone know how to change this back, or how it occurred? TIA


2 REPLIES 2

sheetmetal bend note orientation

I'm not for sure how it occurred in your situation, but I always thought
that it was ABOVE the line if it was a bend UP, and BELOW the line if it
was a bend DOWN.



In your case, these are both bend downs???


Highlighted

RE: sheetmetal bend note orientation

Yes, Both are bend downs.