cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Cabling with Multiple Cable Assemblies

Guest

Cabling with Multiple Cable Assemblies

Good afternoon,

 

I am having trouble routing multiple cable assemblies (different cable assembly models) through the same locations such that they pack appropriately.

 

I basically want to send 4 cables through 2 P clamps such that they stack on top of each other at specified locations (round not flat).

 

I am using Creo 4.0 and my assy structure is as follows.

 

Top level model

-W100 (first cable .asm model)

-W200

-W300

-W400 (fourth cable .asm model)

 

Is there a technique to route/pack 4 separate models?

 

Thanks,

1 REPLY 1
Highlighted

Re: Cabling with Multiple Cable Assemblies

I would recommend using shared networks between your different harness parts. You can create a network in W100 and share that network for the 3 following harnesses.

 

http://support.ptc.com/help/creo/creo_pma/usascii/index.html#page/electrical_design/cable/using_netw...

John Piotrowski, Co-Founder & Product Manager
CadActive Technologies - www.cadactive.com
Announcements