Circuit data table parameter

[rkrishna]

Any one please help me, How to give the connector designation (location) parameter in circuit data table.

I want to give the connector designation location in circuit data table (Drawing).

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[rkrishna]

In Detail, W1 wire connected to connetcor C1 and C2. my flat view is in 2nd sheet but my wire list table/circuit data table is in sheet 1. I want to show the drawing location of C1 and C2 connctor locations in wire list table/circuit data table...

what is the parameter for connector designation location in wire list table.

I want to show drawing location Drawing grid (A1, A2, A3...like) for connector designation in wire list table.

For example: w1 wire is connected bet ween c1 and c2. I want to show where are c1/c2 connector in drawing location.