I am trying to translate my assembly into a JT file, everytime I have a succeful translation all of my harness straps that the size is currently controlled by Flexibilty fail. The assembly shows the straps at the corrected size, then I translate them to a JT file and they go back to the original pre flexiblity size. I have made sure its the original assembly and drawing that I upload yet no luck.
@Jaime_Lee Please move this discussion in Creo forum. here: https://community.ptc.com/t5/Creo-Modeling-Questions/bd-p/CreoModeling
A new case for PTC's tech support: https://www.ptc.com/appserver/cs/case/case_logger.jsp