cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Creo Cabling Marker Cosmetic Reference to Cable Segment Undefined

slibert
1-Newbie

Creo Cabling Marker Cosmetic Reference to Cable Segment Undefined

I'm using Creo Parametric 3.0's Cabling Application.

 

In the Creo Wire Harness Assembly, the following steps are followed:

 

- Create a new Harness Part.  The remaining steps occur within the context of this new Harness Part.

- Create two Connector Parts ("A" and "B")

- Create a Cable ("C")

- Route the Cable between Entry Ports on the two Connector Parts, observe a new Cable Segment "D" is created as well.

- Add a Cable Location "E" in the middle of the Cable

- Split the Cable at Cable Location "E", forming Cable Segments "F" and "G"

- Insert a Marker Cosmetic which is associated with  Cable Segment "D"

- Create a Bundle (no spool) "H" containing the Cable, with endpoints at the Entry Ports on each Connector Part

 

Observe that:

 

- Once the Bundle is created, Cable Segments "F" and "G" have been automatically removed, and replaced with a new Cable Segment "I".

- In the Reference Viewer, the Marker Cosmetic now has an Invalid Reference to no-longer-existant Cable Segment "D".

 

*** Detailed Reference Info ***

 

Reference #1:
Reference Type: Feature reference
Used As: Local geometry reference

Warning: The reference is missing.
Referencing Solid: PRT0004.PRT
Referencing Feature: J48 

Reference is in the Context of: PRT0004.PRT

Referenced Solid: PRT0004.PRT
Referenced Feature: *Cable/Bundle Segment id 3238 (Missing Feature)
Referenced Entity Id: 3238
Referenced Entity Type: Feature

Full Path: Warning: The reference is missing.


J48 -> PRT0004.PRT -> *Cable/Bundle Segment id 3238 (Missing Feature)

 

*****************************************

 

1) Is this behavior expected?

 

2) Is there any method or workaround to resolve this?

 

Thanks,

 

- scott


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Top Tags