cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about the Community Ranking System, a fun gamification element of the PTC Community. X

Creo ECAD

cc-2
6-Contributor

Creo ECAD

Hello

I am curious to know why there is no specific section for ECAD in this forum ? Does that mean that Creo is not used for ECAD and schemantic designs ?

 

I am trying to find out if Creo fully support IEC81346

 

I have found this thread below which is now closed and it would appear that in the past this was not the case.

However, I could not find any update nor could I find a datasheet telling me which IEC standard Creo supports.

Thank you in anticipation for any clue 🙂

 

https://community.ptc.com/t5/Creo-Parametric-Ideas/Feature-names-with-special-characters-and-to-document-Reference/idi-p/459036

1 REPLY 1
StephenW
23-Emerald II
(To:cc-2)

ECAD is in the Routed Systems under Creo Parametric

https://community.ptc.com/t5/Routed-Systems/bd-p/routedsystems

Top Tags