cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Creo Schematics 3 compatible with Parametric 7 if we use Teamcenter PLM?

Ramesh_Mani
6-Contributor

Creo Schematics 3 compatible with Parametric 7 if we use Teamcenter PLM?

RSD Users!

 

The below matrix says that, CS 4.0 is interoperable with Creo 7 parametric. What it means if we use different PLM (Teamcenter) other than Windchill? How this will impact us?

 

- We are using Creo Schematics 3, Creo 4 Parametric with Teamcenter PLM Planning to upgrade Creo 7.

- Parametric Any impact on Creo Schematics 3? Do we necessarily need to migrate to CS 4 or CS 7?

 

Thanks,

Ramesh

1 ACCEPTED SOLUTION

Accepted Solutions

Hi Ramesh, 

Creo Schematics has nothing to do with Teamcenter (this is for any version of Creo Schematics) - so if you used to work with Windchill, and you are transfer to Teamcenter -> you will loss the ability to check-in/check-out designs to your PLM system from Creo Schematics UI , including generation of secondary content during check-in. 

Creo Schematics 4.0 works fine with Creo 7.0 , take into account Creo Schematics 7.0.0.0 was released - you should consider to upgrade . 

if you comparing to CS3 there is new functionality and lot of SPRs were resolved.... 

Regards, 

Gaby

 

View solution in original post

2 REPLIES 2

Hi Ramesh, 

Creo Schematics has nothing to do with Teamcenter (this is for any version of Creo Schematics) - so if you used to work with Windchill, and you are transfer to Teamcenter -> you will loss the ability to check-in/check-out designs to your PLM system from Creo Schematics UI , including generation of secondary content during check-in. 

Creo Schematics 4.0 works fine with Creo 7.0 , take into account Creo Schematics 7.0.0.0 was released - you should consider to upgrade . 

if you comparing to CS3 there is new functionality and lot of SPRs were resolved.... 

Regards, 

Gaby

 

Ramesh_Mani
6-Contributor
(To:Gaby_K)

Thanks much Gaby, it really helps!

Announcements
Top Tags