cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Harness Manufacturing & 90° Backshells?

Highlighted
Regular Member

Harness Manufacturing & 90° Backshells?

I have wires autorouted to connectors. Some of the connectors have 90° Backshells.


What are the tips and tricks out there to actually get my backshell to line up with the connector and the routed cables again?


The connector and backshell are no longer constrained to one another in Harness MFG, so once I bend the wire to try and get it to follow thru the backshell, location points begin to overlap & fail, the backshell and connectorare not aligned... etc.


I know this is nothing new - I am still using WF4 - Just looking for experienced advice.


Thanks!