cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Ribbon cable modeling

Carlos.Castillo
2-Guest

Ribbon cable modeling

Hello, everyone:

I am trying to model a coloured ribbon cable 24AWG (8 conductors), and my question is: can I modify the pitch between conductors? Right now i have .2 mm between conductors centerlines... but my connector has 2.54 mm pitch. So i would need my ribbon cable to be the same 2.54 mm pitch. Can I do this in CREO? I would appreciate your support.

Capture.PNG

1 REPLY 1

Hope this helps
 
Article - CS66721

Ribbon cable width cannot be changed in Creo Parametric

Modified: 24-Aug-2020   

Applies To

  • Creo Parametric 1.0 F000 to 7.0.1.0

Description

  • Ribbon cables with distance in between the cable conductors cannot be created such like
O-O-O-O-O-O     instead of     OOOOOO
  • Ribbon spool parameter WIDTH does not work
  • Ribbon cable width cannot be changed

Resolution

 

Top Tags