cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X

Basic of Ball Connection (Mechanism)

KshetrabasiMaha
1-Newbie

Basic of Ball Connection (Mechanism)

This is a basic idea about ball connection for the beginners in Pro-e Mechanism

 

 

 


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
4 REPLIES 4

how do you put constraints to the mechanism? For example how can you make the ball to move inside a cone of 12 degrees? Of course the tip of the cone should be the datume point used for the definition of the ball mechanism.

Hi

The option you are asking is in CREO (cone of 12 degree)

ball_connection.JPG

Also the same can be achieved in Earlier version with 2 pin connection with one dummy part

Regards

K.Mahanta

NICE!!!!  Only available in CREO...

This is something that's missing in WF5.

thank you

Hi

You can also achieved the same type of movement in Earlier version with 2 pin connection with one dummy part.

Regards

K.Mahanta

Top Tags