Get Help

Turn on suggestions

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for

- Community
- :
- Creo Parametric
- :
- Simulation
- :
- Creo Simulate graph results - Maximum point?

Options

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for

Highlighted
##

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Notify Moderator

02-09-2020
08:41 PM

02-09-2020
08:41 PM

Creo Simulate graph results - Maximum point?

Hi, I get a graph result on one of the edges of a beam, it looks like this.

Since the point on the graph is kind of random, I'm curious how does the Creo Simulate picks the points that are shown to me? Is the maximum point I see in this graph has to be the maximum stress along the whole curve?

Thanks!

Labels:

1 REPLY 1

Highlighted
##

- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Notify Moderator

02-26-2020
02:03 AM

02-26-2020
02:03 AM

Re: Creo Simulate graph results - Maximum point?

The points on the graph are calculated based on the type of mesh, if you mesh using the mesh controls such as Mapped Mesh or Prismatic you can get the points displayed at uniform intervals as shown in the figure. Also the maximum point you see in the graph corresponds to the maximum stress of the point at that location on the edge but not for the whole cure.

Announcements