Loads for simulations

[DavidKhan]

Hi all

i want to know that if i have a mechanism and i want to do its dynamic analysis in creo simulate.Now the only information i have is that of the rpm and power of motors connected with the pinion gears.

From where i should get the forces and loads that is applied to the meshed gears.Whether i should calculate all these forces or torque manually? or there is any other method that can done in the software to avoid manuall calculation.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[SylvainA.]

The first question to answer is: what do you want to calculate with this dynamic analysis ?

Mechanically speaking, you cannot often impose the speed and the torque of a motor.

It is defined by the equilibrium point between the torque/speed curve of the motor and the load curve of the mechanism driven by the motor.