Hello,
I have attached an image file for your reference.
I want to perform the following, please help to do the the same.
1. The blue disk has one pin (which holds spring) and two stopper (red)
2. The yellow block has a slot where that spring's other end point is located.
3. The stopper postion angle is 120 degree
Requirement:
The disk rotates with ~10-15 RPM anti clockwise
The spring will generate tension.
Once the pin will come as ~12o clock position, it will tend to move the yellow block from its slot and pull it.
I want to animate the spring compression so the yellow block moves to the next stopper.
Please help if anyone have the idea to execute.
Amit
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
