cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can Bookmark boards, posts or articles that you'd like to access again easily! X

Structure with commercial extrusion

fstopelli-2
14-Alexandrite

Structure with commercial extrusion

Hi!,

I would like to analize a structure made by estrusion (see attached file), 

but generating mesh is very slow, it i possible to increase the speed of elaboration?

are there any simulation tips to follow in this situation?

 

Thank you

 

  

6 REPLIES 6

It depends what you look for. You might use large mesh as default setting and intensify it only where you feel there are bigger gradients. If it is a parte of a bigger assembly (so you are not focused over this extruded bars), you might also use beams by specifying their section in beams' definition.

fstopelli-2
14-Alexandrite
(To:gfraulini)

From datasheet I know Jyy e Jzz but not J

I have to use "Sketch" command?

Yes, you need to sketch your own section.

fstopelli-2
14-Alexandrite
(To:gfraulini)

So what does it mean?

You simply have to put a point where the shear center is within the sketch environment.

 

https://theconstructor.org/structural-engg/shear-center/3677/

 

 

fstopelli-2
14-Alexandrite
(To:gfraulini)

H gfraulini Pearl,

Can I use also a shell element to model the structure?

I seem correct but If I see "Review Geometry shell doesn't appears

 

Top Tags