cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Trajectory Simulation

Newbie

Trajectory Simulation

Dear all

please help me in this case

I have three trajectories & I have a cylinder that

slide up & down while the trajectories rotate

when the 1st one rotate it make the cyl doesdown

for 2mm then when the second rotate it make goes

down for another 2mm &the the third hassame senario

Ihave to mention that every one of the trajectories

has its shape to let the cylmove up or down

the problem I tried to use cam follower but the sys

refuse to identify the trajectory as a cam

I used a slot connection it works fine for one

trajectory but when I tried to add the second

trajectory nothing goes right

I added a pic that i hope it may explain the

problem

Untitled.jpg

please help me as soon as possible

thanks alot

2 REPLIES 2

Re: Trajectory Simulation

Verify that that movement is only in 2 directions.
As far as I know, 3 dimensional cams are still not supported by Pro/Mechanism. (Hopefully this has been fixed)

See if cam liftoff is enabled.

Hope this helps,

Don Anderson

Thanks,
Don Anderson
No time Like the Present!

Re: Trajectory Simulation