It's probably the wrong category to post this question, but it seems like the more relevant ones hav...
Hi, I have no idea to fix this problem
Hey Guys, I'm creating a kind of lift at the moment and want to do this with mechanisms, to see if e...
(view in My Videos)
As for a simple example, i have 2 parts which is screwed with a preload of 20kn. The parts are in co...
Hi, is it possible evaluate reaction measure for constraint relative user-defined frame? Thank you
workaround att. (view in My Videos)
I am trying to save the animated result of a static simulation. Every website, including PTC, says t...
8 Replies 1218 Views
Hi, everyone. Here's hoping someone recognizes this problem. I have a simple assembly with an arm an...
Whenever I launch Creo Simulate, I see the display of mode of analysis as shown in the image. how to...
(view in My Videos)
Actually, i am working on a differential which getting some forces from pinion. These forces would m...
3 Replies 1369 Views
I have a large model of all the significant structures of a frame that contribute to the mainframe s...
Hello, I tried to create mapped hexamesh for a full symmetric geometry. The first side was OK, but t...
2 Replies 825 Views
Hello, I am trying to run a design optimization study for feasibility, using two radii on a connecti...
Hi all, If I star an optimization study, the log reports that Creo2 is being started in the backgrou...
Hello, I am trying to run a design optimization study for feasibility, using two radii and an extrud...
I'm trying to set up a design study where I rotate a crankshaft and the load vectors and magnitudes ...
Dear Community, I need your help The purpose of the simulation would be to simulate the passage of a...
I cannot figure out how to make a parametric driven table that has limits. I understand how to use t...
4 Replies 1944 Views
Hello, I have been using simulate for a while, and recently an error doesn't stop from happening. I ...
hello all, i want to analyse this housing for torsional stress. but when i start meshing it is showi...
4 Replies 808 Views
Hello all I remember to have had similar issue in Creo Simulate 2.0 and now I see it also in Simulat...
Hi everybody, I want ask you where and why one need to use Max, Mid, Min or Max Shear principal comp...
Hello all, I am using this software from 2 weeks now and was able to complete and understand some of...
In the past I was using the following function which apparently got me the matrix for a sheet. statu...
Hi, I have a fixed - free bar with tichness 40 [mm]. the deflection is 0,2 [mm] with F = 4.000,00 [N...
Hi, If I know a vertical force (in red), is it possibile evaluate a horizontal force (in Green)? (Se...