I've just been testing this on a VM not a real laptop, but I think it should perform the same. I'm confused.
I ran C:\ptc\Creo 2.0\Simulate\bin\simulate_borrow.bat. I borrowed the license for 1 day, and then I looked at ptcstatus: PROE_AdvSE 3 7 ^(dave@xxxxx) PROE_AdvSE PROE_Flex3C 2 18 (duffy@xxxxxx) PROE_Flex3C (santos@xxxxxxx) PROE_Flex3C (designers@) PROE_Flex3C MECBASICENG_License 0 22 MECBASICUI_License 0 22
This shows that I borrowed the Creo Parametric License PROE_AdvSE, But MECBASICENG & MECBASICUI show no licenses borrowed.
Shouldn't I see one of them borrowed. Also how do I borrow a parametric, simulate and mathcad license at the same time?
When I configure licenses, I don't see a way to add simulate to a license configuration I would pick when I borrow the license.
David Haigh Phone: 925-424-3931 Fax: 925-423-7496 Lawrence Livermore National Lab 7000 East Ave, L-362 Livermore, CA 94550