cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

CGM created from a drawing have splits and curves

RGE
1-Visitor
1-Visitor

CGM created from a drawing have splits and curves

The cgm file created from drawing using File->Save a Copy..*.cgm is not equal to the drawing opened in ProE.

The cgm has splits in between lines and extra curves.

Please find the snapshot attached

Is there any settings which can resolve the issue.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
3 REPLIES 3
VladimirN
24-Ruby II
(To:RGE)

Hello!

What version of Pro/E are you using?

RGE
1-Visitor
1-Visitor
(To:VladimirN)

Wildfire 3.0 M250

Setting intf2d_out_cgm_ver to 3 (default is 1) in config.pro is making some difference, but cgm created is having disjoint edges and there are curves

VladimirN
24-Ruby II
(To:RGE)

Could you provide a drawing sheet?

Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags