cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Cannot access Spinal Bend Command (greyed out)

ptc-128796
1-Visitor

Cannot access Spinal Bend Command (greyed out)

I have Creo Parametric Datecode M030 on a network license. I am unable to use the spinal bend command, however other computers/users on our system running the same setup and config do not have this issue. I've tried reconfiguring, reloading the software, and connecting to specific licenses to guarentee I'm accessing an advanced license but nothing seems to solve the problem.....What am I missing? Anyone have any suggestions?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags