cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Component Drag

dasher
7-Bedrock

Component Drag

How do I enable CTRL+Alt LMB for Component Drag?

I was able to do it prior to a new install on my machine and now I can't. Is there a config.pro setting I need? I thought it was a standard setting.

Thanks


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
ACCEPTED SOLUTION

Accepted Solutions
dasher
7-Bedrock
(To:psobejko)

Thanks for the response.

I found the issue. enable_implied_joints no.

I just removed it and all good now.

View solution in original post

2 REPLIES 2
psobejko
13-Aquamarine
(To:dasher)

Maybe this one? modify_offset_during_comp_drag yes ?

dasher
7-Bedrock
(To:psobejko)

Thanks for the response.

I found the issue. enable_implied_joints no.

I just removed it and all good now.

Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags