cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about the Community Ranking System, a fun gamification element of the PTC Community. X

Creo 2-m030 export to pdf

davehaigh
12-Amethyst

Creo 2-m030 export to pdf

It doesn't appear as though Creo is paying attention to my pen table file when exporting to pdf.

The config editor shows that the config option is loaded:
[cid:image001.png@01CDDF8A.C47E60F0]

And I have use pen table checked in the setup dialog:
[cid:image002.png@01CDDF8A.C47E60F0]

But the line weights in the pen table file are ignored.

One other question. Anyone know where a saved profile is saved to? Notice in the screen shot above pdf_mono is the profile I saved.

David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2

Ah, found my own problem. The config that I loaded to reset the pen table file was loading the pcf file instead.

Still like to know where the export profile gets saved.

David Haigh
Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags