Creo 2 - what replaces these config options?

[davehaigh]

I noticed that two config options we use are no longer valid in Creo 2.0

Are there other config options that replace the fuction of these two options?
sketcher_dec_places 3
tol_mode PLUSMINUSSYM


David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[DonSenchuk]

I thought I read that these were both made obsolete.

[davehaigh]

I know these options are gone. Why?

How did the software change, such that these are no longer needed?


David Haigh

[MikeBills]

Going from WF4 to Creo 3.0 soon.  I'd also like to know if there are replacements for these 2 obsoleted config options.  Anyone have an answer?

[mender]

tol_mode was obsoleted in Creo 1 by the introduction of detailing options for solids, File > Prepare > Model Properties > Detail Options, 'default_tolerance_mode'.

sketcher_dec_places I have less direct knowledge of, it appears that it was obsoleted in WF5 and employs 'default_dec_places' instead.  I could be mistaken, so test before relying on that.

[davehaigh]

I know they are gone. But why?
What changed in the software to make these no longer needed?

David Haigh