Creo2 Schematic default files

[jstone]

Where do you set (or configure) the default configuration, ui, ect. files location?  I thought it was on install.  IT finally loaded the licence and we are moving to Windchill 10.2 so I'm trying to get schematic ready.  I take it the Creo 1 Schematic files should work.

Thanks,

jef

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[JimBarrettSmith]

Jef

Please take a look at this link http://help.ptc.com/creo_hc/creo30_schem_hc/usascii/index.html#page/schematics/schematics_hc/About_System_Default_Files.html

If the topic does not help then please let me know

thanks, Jim

[jstone · Accepted solution]

Jim,

Great, that was it.

Thanks,

jef