Hello all, does anyone know what, if any, config option controls the datum point tag position (on a drawing). Please look at the attached image, i want to get the text position a little closer the yellow dots. These dots are datum points on a curve & i have renamed the point 1,2,3 etc (deleting the pnt for simplicity). I have searched through my dtl file but cannot find anything that will do this.
Another question while i have your attention. I have created a hole table for these points, i have 12 points in total. When the table is created, the points are listed in the first column numerically, only they are not, they read, 0,1,10,11,2,3,4,5,6,7,8,9. Maybe this is normal behaviour, but i would like them displayed in true numerical order, 0,1,2,3,4,5,6,7,8,9,10,11
can this be done?
Regards
John
