cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Datum point tag

John.Pryal
14-Alexandrite

Datum point tag

Hello all, does anyone know what, if any, config option controls the datum point tag position (on a drawing). Please look at the attached image, i want to get the text position a little closer the yellow dots. These dots are datum points on a curve & i have renamed the point 1,2,3 etc (deleting the pnt for simplicity). I have searched through my dtl file but cannot find anything that will do this.

Another question while i have your attention. I have created a hole table for these points, i have 12 points in total. When the table is created, the points are listed in the first column numerically, only they are not, they read, 0,1,10,11,2,3,4,5,6,7,8,9. Maybe this is normal behaviour, but i would like them displayed in true numerical order, 0,1,2,3,4,5,6,7,8,9,10,11

can this be done?

Regards

John

2 REPLIES 2

do you ever get an answer to this question?

John.Pryal
14-Alexandrite
(To:jtrowbridge)

No, never figured it out, didn't even get any replies, until now. Sorry.

Regards

John

Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal


Top Tags