Displaying tolerances on dimensions in drawing
‎May 11, 2010
02:14 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎May 11, 2010
02:14 PM
Displaying tolerances on dimensions in drawing
How do I display tolerances on dimensions in a drawing? I have the solid model dimensions toleranced the way I want them to, but i cannot get the tolerances to display on the drawing when I add dimensions. I have tried to use some of the config options: display_dwg_tol_tags to YES tol_display to YES tol_mode to plusinussym Thanks in advance.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
1 REPLY 1
‎May 11, 2010
03:59 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎May 11, 2010
03:59 PM
Philip There is an option in the drawing options for showing tolerances under the same name as the config.pro one. Go to file/properties/Drawing options. It should be down the list a bit. This allows the tolerances to show in the drawing without having them show in the model screen. Next you can choice the type of tolerance in the dimension properties once the option is set. This all applies to drawings. Regards Eric