Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X
Hello,
I'm new to Creo Elements. I started building a part which I would need to 3d print later. I was very surprised that, after looking all the first steps videos, I was able to create this part without much problems.
After I was finished, I tried to blend one of the edges of my model again, but now the error message "Edge is tangential - cannot be blended" always appears when I try to blend an edge.
I'm sure I'm missing something essential, hopefully one of the more experiences persons here in the forum can solve my problem. I attached my (very small) project file.
Thanks for any help!
Markus
Solved! Go to Solution.
Hi Markus
this is normal, you can not blend a blend.
If you choose an edge you get the error message.
But If you choose the surface you can change the radius of the rounding or delete them.
Hope this helps
.
Hi Markus
this is normal, you can not blend a blend.
If you choose an edge you get the error message.
But If you choose the surface you can change the radius of the rounding or delete them.
Hope this helps
.
Great answer, thank you. My problem was, that I didn't zoom in deep enough to be able to choose the surface, so I didn't even mentioned the possibility to mark them.
Thanks again for your help
Markus