Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email.
X
Hi All, I am running a simple analysis on a sheet metal part and running into the below error message. I checked the material assignment and its from library. The same analysis will run if the slot length is small. Any thoughts?
Hi All, I am running a simple analysis on a sheet metal part and running into the below error message. I checked the material assignment and its from library. The same analysis will run if the slot length is small. Any thoughts?
Have you tried running a modal analysis to find the unconstrained DOF, as suggested in the last yellow warning? This often shows the problem very clearly.
