cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can Bookmark boards, posts or articles that you'd like to access again easily! X

I have set a part bend allowance table for my company ,how to set it on the config.pro?

mgupta-4
1-Newbie

I have set a part bend allowance table for my company ,how to set it on the config.pro?

Dear All,

 

I have a part bend allowance table that is fixed by my company and everytime when I open my sheetmetal drawing it should follow that so how can I set it over config.pro .

 

Or anyother method please suggest.

 

Thanks & Regards,

Manish


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Top Tags