cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you know you can set a signature that will be added to all your posts? Set it here! X

Intel HD 4400

jtynan
1-Newbie

Intel HD 4400

The Intel HD4400 graphics card supports OpenGL 4.3 however freezes for approx 15 seconds on commands like "delete old versions" or "file rename". I have inserted config line graphics win32_gdi and everything works very fast with the exception that the model highlight is poor as expected and usually seen.

 

Any solutions to problem of partial freezes on the "delete old versions" or "file rename" command when using OpenGL. There are other commands which cause this 15 second freeze also but the above are the ones I have seen recently.

 

I know Intel HD4400 on a Toshiba machine is not officially supported however it does support OpenGL 4.3 so any help appreciated. I have updated to the latest drivers on the graphics card also but no improvment.

 

Thanks,

John


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions
jtynan
1-Newbie
(To:jtynan)

All, problem solved by upgrading to Creo 3 M010.

View solution in original post

9 REPLIES 9
Mahesh_Sharma
22-Sapphire I
(To:jtynan)

John,

Is it Creo 2.0?

datecode?

Mahesh,

Yes Creo 2.0. Will check datecode tomorrow.

Thanks,

John

jtynan
1-Newbie
(To:jtynan)

Datecode is M110

Mahesh_Sharma
22-Sapphire I
(To:jtynan)

John,

My first suggestion to you is to update your Creo datecode to M130. Try this first and share the results.

John,

in https://support.ptc.com/appserver/cs/view/solution.jsp?source=subscription&n=CS169272 PTC recommends trying following config.pro options:

enable_opengl_fbo no

enable_opengl_vbo no

enable_opengl_shader no

Martin Hanak


Martin Hanák

Martin,

Thank you for your suggestion. Unfortunately when I set all 3 parameters you have suggested in the config file the problem persists. The only solution i have seen so far is with the win32_gdi line in the config file so it sounds like my graphics card may not be up to it?

John

John,

I am sorry I don't have any other advice .

Martin Hanak


Martin Hanák

Thanks for help anyways Martin.

jtynan
1-Newbie
(To:jtynan)

All, problem solved by upgrading to Creo 3 M010.

Top Tags