cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Model check for drawing : Remove items

Highlighted
Level 12

Model check for drawing : Remove items

Hello,

I would like to run model check interactive on a drawing file. Below is the steps I am following for same:

     File --> Prepare --> ModelCHECK interactive

Once I will do this, I will get one pop up as below:
"ModelCHECK - Run on all drawing models?" with default value as "N"

Could anyone let me know whether it is possible to exclude this pop up once I run model check?

Thanks in advance!

Regards

Ketan

4 REPLIES 4

Re: Model check for drawing : Remove items

You cannot control it. Case is here but you can support this idea.

Re: Model check for drawing : Remove items

Yes there is with a workaround. We created a mapkey, then created icons in our toolbar that points to the different mapkeys.

  • MC mapkey.jpg

 

 

Re: Model check for drawing : Remove items

Know, but it is PTC "workaround" I am not satisfied with. Why pushed to create own icons instead of driving it on existing ones via Yes/No/Ask by config? Only means PTC haven't been thinking about this functionality from user's perspective much...

Re: Model check for drawing : Remove items

A lot of things that we figure out are workarounds for PTC software limitations.