Most reliable Datecode for Creo 2.0.

[ptc-4675898]

Which is the most reliable Datecode for Creo 2.0. Because I am using Creo 2.0 Datecode M080 with Windchill 10.1, But I am facing problem in saving/ regenerating the large assembly.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[BuddyHudson]

Hey Manimaran, M080 was a bad release. M090 is stable so far for us. No issues and seems faster with Windchill PDMLink as well.

Buddy Hudson

[tjones-3]

Bryant, have you had the issue with m090 where the session hangs when attempting to exit?

[BuddyHudson]

Yes, I have experienced this but it does not happen all of the time. 3 out of 10 exits maybe......

[TomD.inPDX]

I am still on M040 and other than very annoying pattering issues (missing instances and/or failures after a certain rotation point), it is quite stable.