Going through the update training I noticed a new configuration file you might skip over it without realizing the significance.
There are now .dtl files for drawings and models. Two separate files with different options.
There is a new config that controls where this file is:
model_detail_options_file <creo_loadpoint>\text\3d_inch.dtl
David Haigh
Phone: 925-424-3931
Fax: 925-423-7496
Lawrence Livermore National Lab
7000 East Ave, L-362
Livermore, CA 94550
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
