Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
I have found that sometimes the value is set, sometimes not. Where can I define the value? So far I could not find any configuration option.
Solved! Go to Solution.
Hello Joshua,
it seems the value of the DTL option wittness_line_offset is used by default.
Regards,
Gunter
Hello Joshua,
it seems the value of the DTL option wittness_line_offset is used by default.
Regards,
Gunter
Yes that's right, but this option also defines the distance of all witness lines to the body edge. Unfortunately this distance according to DIN is defined 0.