Plotter config changes for Creo 3 from creo 2?

[aruzgys]

From creo 2 the plotter config would accept a X and Y Offset number (5 each for us)

Now we have to manually enter this, but i cannot see anything in the notes to any changes for this.

Anyone have any ideas?

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[MartinHanak · Accepted solution]

Hi,

is https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS219524 describing your problem ?

MH

[aruzgys]

Yep, exactly the issue, thanks for the fast response mate.