Folks:
This is most likely OLD hat for the majority of you.
Customer has recently converted from 2.0 to 3.0.
In Drawing mode, upon saving a Layer Change, I am receiving a Pro/e Session failure, thus dumping me out of Pro/E.
Is there a config.pro option I should be looking at th rectify this?
Please advise
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
