Creo 2.0 - Open a drawing from active part?

[Daniel82]

Hi

How I can  use the program with Creo in Italian Language?

[remy]

You need to use Creo in Italian Language.

As there can be multiple possibilities to your question, there is a need to clarify where you are at right now.

Do you mean that you installed Creo and the menus are in English and that you need them in Italian?

[Daniel82]

I work in Italy the program and the menus are in the italian language.

The program open_drawing_cr2.exe for open drw from part not work with italian language, but only with english.

[remy]

Dear @Daniel82 

Creo in Italian is installed correctly and you run a program called open_drawing_cr2.exe.

This is the first i hear about this program.

Can you tell me what it is ? and who supplied you with it?

[Daniel82]

you Can find it at this link 

Is there a button to quickly open the drawing for an on-screen model/assembly ?

is the old discussion in this site 

[remy]

Right Martin Hanak says he created the application and his first post is rather straightforward: it is works in English Creo.

I'll leave it to @MartinHanak to address this topic. 

[Daniel82]

OK I read that the program works in English, I would like to know if another person can help me to make it work with the Italian language

[remy · Accepted solution]

After downloading the application and following the installation and running instructions, Creo is unable to run it in my envionment: our anti-virus system takes down the exe file.
Consequently I'm sorry to inform that i'll be of no support on this topic.