Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts!
X
It seems I need to retract my earlier statement that "this config setting does not seem to be a good choice in conjunction with Intralink."
The issue I was having stems from family tables.
Let me start from the beginning. Several users instructed me to simply move my relation POUNDS = PRO_MP_MASS to the "Post Regeneration" section of the Relations, and use the above config options, and that would solve all my problems. I had tested this, and found that this resulted in oodles of modified parts. I was advised, "It'll only happen once - check those parts in and they'll never be modified again after subsequent mass prop calculations." I tested this, and found it to be untrue - I was STILL getting oodles of modified parts. That's when I made the statement above.
HOWEVER, I've further tested it, and discovered that the issue stems from Family Tables. Specifically, I needed to add the POUNDS parameter to the family table for any part which uses the POUNDS = PRO_MP_MASS relation. Once I did that, it appears to fix the issue.
Thanks to all that helped (and that prompted me to keep investigating!)
--
Lyle Beidler MGS Inc 178 Muddy Creek Church Rd Denver PA 17517 717-336-7528 Fax 717-336-0514 <">mailto:-> - <">http://www.mgsincorporated.com> This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
