Sketcher config.pro option don't work ?

[Sebastien_Delf]

Hello,

I have try to set this option to YES :

sketcher_auto_create_references

But it looks to have no impact on the behavior of the sketcher.

I mean, for example, if I select the face of a cube with a hole inside,

then I go to the sketcher, the only automatic references I've got are the 2 references planes as usual.

I had imagined I will obtain the whole contour of the face selected as references.

Have you try this option ?

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[cprice]

Try sketcher_auto_create_references 2

I believe you just need to add a number quantity instead of yes or no

[Sebastien_Delf]

tested, it's don't works.

[ClintWalton]

There are two options that are quite similar:

"sketcher_auto_create_references" with a default of "no" - (This option controls the automatic reference creation from selected background geometry.)

and

"sketcher_auto_create_refs" with a default of "2" - (The option values are: 2: the system automatically creates 2 dimensioning references; 1: the system automatically adds the orientation reference as a dimensioning reference; 0: the system does not automatically create dimensioning references.)