Third angle projection symbol

[MikeThomason]

Alright gurus....

I've been out of the "Pro" world for a couple years and I'm getting older and my memory is failing. I've also did a seach on the forums and found nothing that helps.

I am trying to modify a drawing format but for some reason I cannot select the third angle projection symbol so that I can move it. I cannot pick on it, put a box around it, nothing.... What am I missing?

Thanks in advance!

Mike Thomason

Beverage-Air

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[MikeThomason]

Looks like we have a winner! I knew it was something simple that I was over looking! Thanks!

*******

The symbol is likely in the format and not the drawing. Draft entities in the format are only visible in the drawing. You must modify the format to make those changes. Be aware, it will change it for all drawings using that format.

Regards,

Darren Guidry

Supervisor - MCAD Systems and Design Support

General Atomics Aeronautical Systems, Inc.