UI
‎Jun 21, 2012
05:06 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Jun 21, 2012
05:06 PM
UI
Creo Community,
I have just finished customizing my ribbon interface and saved it to a
file. (creo_parametric_customization.ui). I have 8 users on a floating
license.
Is there an easy way to load this file on all my users machines, maybe
in the config.pro?
Brad
Creo 2.0 M010
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
I have just finished customizing my ribbon interface and saved it to a
file. (creo_parametric_customization.ui). I have 8 users on a floating
license.
Is there an easy way to load this file on all my users machines, maybe
in the config.pro?
Brad
Creo 2.0 M010
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
2 REPLIES 2
‎Jun 21, 2012
05:41 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Jun 21, 2012
05:41 PM
Rename this file creo_parametric_admin_customization.ui and put it in loadpoint\Common Files\M010\text
‎Jun 26, 2012
03:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Jun 26, 2012
03:50 AM
Customizing the UI in Creo is a nightmare.
You need to go into every mode in the software. I just found out, that activating a part or subassembly in an assembly is not the same as part or assembly mode. Even a skeleton part has its own mode compared to a normal part, but they are the same when activated in an assembly. Go figure....
When adding a general command like "Erase Not Displayed" to the quick access toolbar I would like to have a tickbox saying: All modes
/Bjarne
You need to go into every mode in the software. I just found out, that activating a part or subassembly in an assembly is not the same as part or assembly mode. Even a skeleton part has its own mode compared to a normal part, but they are the same when activated in an assembly. Go figure....
When adding a general command like "Erase Not Displayed" to the quick access toolbar I would like to have a tickbox saying: All modes
/Bjarne