cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X

Translate the entire conversation x

Wildfire 4 on Windows 8

Stanley
12-Amethyst

Wildfire 4 on Windows 8

Hi,

does ProEngineer Wildfiree 4 runs on Windows 8?

Thx

ACCEPTED SOLUTION

Accepted Solutions

I'd say yes. Recently I tested WF4 M220 x64 on Win8 x64 and it installed and ran without problems. Just so you know, PTC supports Win8 only with Creo 2.0, any earlier version of Creo or ProE is not officialy supported.

View solution in original post

1 REPLY 1

I'd say yes. Recently I tested WF4 M220 x64 on Win8 x64 and it installed and ran without problems. Just so you know, PTC supports Win8 only with Creo 2.0, any earlier version of Creo or ProE is not officialy supported.

Announcements
NEW Creo+ Topics: PTC Control Center and Creo+ Portal

Top Tags