cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

datum curve and radius

kklinger
1-Newbie

datum curve and radius

Hello fellow users,
I am trying to create a datum curve through points. I select single or multiple rad and array points or single point, doesn't matter since the outcome is always the same. When ProE prompts to enter the radius, it has a minimum of 1.10. I need a radius of 0.5. I know it can be done since it was done on other very similar models where the location of the datum points were the same with respect to common references. I am using Wildfire 2.0 date code M120.

TIA,

Kirk

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

After contacting PTC support, the solution was to accept the default radius while creating the datum curve and then go back and edit the curve and change the radius.

Thanks,

Kirk
Announcements