cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

modelcheck error can't be erased in a part

Dom_BOUCHARDY
6-Contributor

modelcheck error can't be erased in a part

For design reasons, my R&D department made a chamfer on a part and then made a circle on the surface.
But... modelcheck, as defined, shows us an error: Entities without surfaces likely to be buried(1)


If I choose the feature in the dialog box and click "Ignore Feature", I get this message:

- Ignore parameter added to feature #4909.


I save, clean up my workspace, reopen the room, MC again but... the error recurs.

And if I choose to skip the feature again, I get these messages:

MC_BURIED_SUSPECT - parameter already exists.
Ignore parameter added to feature #4909.


I would like to understand where the MC_buried_suspect parameter is written, and why, my first action is not registered with my part.

Could you help me?


Regards

 
1 ACCEPTED SOLUTION

Accepted Solutions

Yes, PTC support contact me, and we found the solution.

In my check files, i change the IGNORE_OPTION in interactiv mode from N to Y.

 

And it works.

Thanks for your support 🙂

View solution in original post

5 REPLIES 5

Hi @Dom_BOUCHARDY 

 

Can you share the part file?

 

Thanks. 

Hi Dom,

Will it works for you?

MC_BURIED_FEAT_IGNORE_MERGE_FEAT set to NO in config_init

Dom_BOUCHARDY
6-Contributor
(To:snathan)

Hi all,

 

@snathan: i don't have this option in our config_init.mc

Also, we want to test our 3D models so that they don't have burried functions.

 

@Mahesh_Sharma: Yes it is possible, but for privacy reasons I will open a PTC incident.

 

Regards

Hi @Dom_BOUCHARDY 

 

Did you manage to get solution from PTC TS?

 

Thanks. 

Yes, PTC support contact me, and we found the solution.

In my check files, i change the IGNORE_OPTION in interactiv mode from N to Y.

 

And it works.

Thanks for your support 🙂

Announcements