cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

sheet metal flat in drawing mode

cadjunky
1-Newbie

sheet metal flat in drawing mode

I was wondering if there's a config option which will eliminate the radius
tangent lines in the flat and instead have a phantom line which would
represent where the bend line would be at.




Best Regards,
Steve Voelz
Piping Designer
Pure-Flo MPC, ITT Industries
9625 55th St
Kenosha, WI 53144
Phone #(262)-654-6466 x324
Fax #(262)652-7337

-

Running:
Wildfire build M160
Dell Precision 360
2.8 Pentium 4
FX Quadro 500
1 GB Ram
Windows 2000 NT



visit our web site at: http//www.itt.com

This e-mail and any attachment contains information which is private and
confidential and is intended for the addressee only. If you are not an
addressee, you are not authorized to read, copy or use the e-mail or any
attachment. If you received this e-mail in error, please notify the sender
by return e-mail and then destroy it.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements