using Automation interface to 'Reconcile model'

[EP_9964574]

Hello, 

I have a issue in using Automation interface to 'Reconcile model' using  vbscript error. 

I am using below coomand but getting error( cannot use parenthesis when calling a sub):

---------------------

Set objManager = CreateObject("Studio.ModelManager")
objManager.ReconcileModel("\\SQL\MyServer@MODELER\MyDatabase\MyModel\0.0.1","C:\MyLogFiles\MyLogFile.txt")

-----------------

When i remove parenthesis,  get a error ( wrong number of arguments or invalid property assignment). 

your feedback is appreciated. 

Thanks, 

[PatrickOllerton]

Hello,

I've moved this to a new thread, it should not have been posted in the previous thread as it's not related.

If you have a Support contract, you can raise with them for assistance with this. 

regards, Patrick

[VladimirN]

"Case Logger": https://www.ptc.com/en/support/case-logger 

[VladimirN]

Here are some helpful articles:

• "Integrity Modeler Reconcile or Rebase process will fail if the model contains a property whose definition has been removed": https://www.ptc.com/en/support/article/CS348176
• "When an integrity Modeler Reconcile is carried out which versions of the Model are compared": https://www.ptc.com/en/support/article/CS299712
• "Removing an Integrity Modeler temporary model version after a failed reconcile": https://www.ptc.com/en/support/article/CS262764
• "Permissions required to reconcile or rebase a model in Integrity Modeler": https://www.ptc.com/en/support/article/CS305230

[EP_9964574]

The problem is not when i reconcile through 'Model explorer' but when i do it using Automation interface custom script . using the below VBS script. I am unable to pass two parameters. it says not to use parenthesis if i remove ,it says wrong number of parameters. 

Set objManager = CreateObject("Studio.ModelManager")
objManager.ReconcileModel("\\SQL\MyServer@MODELER\MyDatabase\MyModel\0.0.1","C:\MyLogFiles\MyLogFile.txt")

urgent!!

Thanks,