Conditional Routing in the procedures

[oparfon]

Good day Community,

 I am wondering if you know something about the condition based procedure flow  for the VEC. Is something like this on the roadmap?

For example:

 if the step instruction  said

“step 10: If any of the 3 sensors is dirty, go to step 15”

Step 11: Move to next check location

..

..

Step 14 : do A and B and  C and hen skip to step 16

Step 15:  follow these cleaning steps … first XXXXX, then YYYY etc .. finally ”

Step 16 : proceed normally

So that after step 10 we are going directly to step 15

A lot of customers asking about this capability?  What is your ideas regarding it?

Best Regards

Olena

[tmccombie · Accepted solution]

Hi @oparfon 

You can navigate to any step needed in Vantage by going to the Step List. The Step list is available in the upper left corner: 

Once in the step list - users can choose to view any step in the procedure:

This would require the user to manually navigate to that step. 

[mkron]

Olena,

We did this similar to the way tmccombie recommended. 

We had a step that was solely for routing.

So it would the operator would following the step (say step 😎 to determine if any of the sensors were dirty.

Then the next step would say 

"If any of the 3 sensors is dirty, continue to the next step.

If they are all clean, go to step 11"

If would be great if there could be some software/application routing, we would use that all the time.