Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X
When Creo View publishes an assembly, it publishes the Master Rep. Is there a way to have Creo View publish the Default Rep instead?
If not, is there a way to enable access to Simplified Reps in Creo View?
@mszwabowski wrote: When Creo View publishes an assembly, it publishes the Master Rep. Is there a way to have Creo View publish the Default Rep instead? If not, is there a way to enable access to Simplified Reps in Creo View?
In the recipe editor go to Parameters > Author States
select "Simplified Reps"
I also have everything else selected on this tab also.
