cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Change in Standard part for new design

Highlighted
Contributor

Change in Standard part for new design

Dear Experts,

 

I have a situation where new design requirements needs a change in available standard library objects from Windchill.

This brought us to situation to save as of standard parts and modify for new requirement , but then the new part is not standardised nor classified, causing duplicate creation of the objects.

Advice some best solutions you have been following to address such cases.
We have too many duplicates created for the part with same geometry.

 

Thanks

Murthi