cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Commonspace Dependency

Highlighted

Commonspace Dependency

Hey Folks
I'm an intralink newbie - I know just enough to make me dangerous!
I am importing a 135 drawing package from Pro 2001 into Intralink 3.3 thru
Wildfire I.
I have successfully Checked In all the assemblies and parts and most of the
drawings.
When I try to check in the four top level assembly drawings I receive a
message:
"DEPENDENCY FOR THIS OBJECT IS NOT AVAILABLE IN THE COMMONSPACE"
The assemblies on these drawings have been checked in, the folder is set, I
do have reoccurring GHOST parts which I will be attempting to purge but I
was wondering if anybody has any suggestions as to how to stop this
conflict?

Thanks in advance

Martin T. Brown
Alexander & Associates
307 New York Ave.
Oak Ridge TN 37830
(865) 483-3314
This electronic mail (including any attachments) may contain information
that is privileged, confidential, and/or otherwise protected from disclosure
to anyone other than its intended recipient(s). Any dissemination or use of
this electronic email or its contents (including any attachments) by persons
other than the intended recipient(s) is strictly prohibited. If you have
received this message in error, please notify us immediately by reply email
so that we may correct our internal records. Please then delete the original
message (including any attachments) in its entirety. Thank you.